Ford Bronco Sport Oil Change Guide

Is changing the oil in a Ford Bronco Sport difficult? That depends on your level of expertise, as well as your home setup! For most St Louis and Fenton drivers, changing the oil in a Ford Bronco Sport is perfectly doable with the right tools and technique. And with Sunset Ford St. Louis on your side, you can do anything. Learn what you’ll need to get the job done, and feel free to contact us in St Louis with any questions about oil changes!

What Do I Need to Get Started?

An oil change requires quite a few tools and supplies, but once you have what you need, you’ll be able to perform your own oil changes regularly. Feel free to stop by our parts department in St Louis if you’re missing anything from this list:

• 5W-20 engine oil
• Oil filter
• Crush washer
• 13mm socket, 15mm socket, ratchet
• T30 Torx bit or wrench
• Drain pan
• Oil filter socket or wrench
• Rags
• Funnel
• High-flash solvent (something like brake cleaner, acetone, or paint thinner)

How Do I Change My Oil?

Now you have your supplies, and it’s time to get going! Our Ford Bronco Sport oil change guide will teach you the basics, but refer to your owner’s manual for information tailored to your particular model.

1. Warm up the engine to make sure everything is flowing smoothly, then park the car in your working area.
2. The front skid plate is held in place by the T30 and 13mm bolts, so you’ll need to remove them first. This gives you access to the oil filter and drain bolt.
3. Place your drain pan beneath the car and make sure it can catch the oil from the drain plug. Once everything is where it needs to be, remove the drain bolt and let all of the oil drain away.
4. Take a look at the o-ring of the drain bolt and make sure there is no damage before you put it back. Otherwise, get a new one.
5. Replace the drain bolt and tighten it once all the oil is fully drained.
6. Look for the oil filter housing across from the drain bolt. Pull out the old filter and replace it with a new one.
7. Pop the hood and add fresh oil to the car. Your owner’s manual will tell you how much oil to add.
8. Start the engine to build oil pressure and then shut the engine off.
9. Check underneath the vehicle to make sure there are no leaks or issues.
10. Reinstall the skid plate and recheck the oil levels.
11. If everything looks good, reset the oil life monitor. Turn the ignition key to the on position or push your push-button start without pressing the brake pedal. Use the steering wheel controls to select “Settings” > “Vehicle” > “Oil Life”. Press and hold “OK” until you see the “Reset Successful” message.

Learn More About Ford Maintenance at Sunset Ford St. Louis

Now that you’ve read our Ford Bronco Sport oil change guide, you’re an expert! But if you need extra advice, we’re just a short drive away from Arnold. Whether you want to pick up supplies at our parts department or just schedule an oil change at our service center, our team would be happy to assist you with all of your maintenance needs! Contact us to learn more or just stop by St Louis.